In DMZ sull'hub di sky immagino, giusto?
E se togliessi solo l'USG e lasciassi tutto il resto (switch poe con i vari altri switch più semplici, l'antenna) funzionerebbe?
Stamattina ho fatto delle ricerche sul sito della Ubiquiti e ho chiesto alla loro ai se il cloud gateway ultra supporta MAP-T. Ecco la risposta:
"UniFi GPT
Yes, the Cloud Gateway Ultra supports MAP-T (Mapping of Address and Port using Translation). This feature is part of its advanced networking capabilities, which also include license-free SD-WAN, WireGuard, L2TP, OpenVPN server, OpenVPN client, OpenVPN and IPsec site-to-site VPN, one-click Teleport and Identity VPN, policy-based WAN and VPN routing, DHCP relay, customizable DHCP server, IGMP proxy, and IPv6 ISP support."
Ho anche chiesto come configurarlo con Sky wifi ed ecco la risposta:
"To configure your Cloud Gateway Ultra to work with Sky WiFi in Italy, follow these steps:
Steps:
Connect the Cloud Gateway Ultra:
Connect the WAN port of your Cloud Gateway Ultra to the LAN port of your Sky WiFi router using an Ethernet cable.
Access the UniFi Network Application:
Open a web browser and navigate to the IP address of your Cloud Gateway Ultra.
Log in with your UniFi credentials.
Configure WAN Settings:
Go to the Settings section in the UniFi Network Application.
Navigate to Internet and select the WAN interface.
Set the connection type to DHCP if your Sky WiFi router provides IP addresses automatically. If not, you may need to enter a static IP address, subnet mask, gateway, and DNS servers provided by Sky.
Enable MAP-T (if required):
If Sky WiFi uses MAP-T (Mapping of Address and Port using Translation), ensure that this feature is enabled on your Cloud Gateway Ultra. This can typically be found under advanced network settings or IPv6 settings.
Configure LAN Settings:
Go to the Settings section and navigate to Networks.
Create or modify the LAN network settings to match your desired internal network configuration.
Adopt UniFi Devices:
If you have other UniFi devices (e.g., access points, switches), adopt them into the UniFi Network Application by following the device adoption process.
Test Connectivity:
Ensure that your devices connected to the Cloud Gateway Ultra can access the internet."
Quindi, anche se loro dicono di collegare la wan dell'USG sulla lan dell'hub, se supporta MAP-T dovrebbe essere possibile collegarla direttamente all'ONT.
