x_term
Non lo so che area sia, dove controllo? Sono nel comune di Altavilla Vicentina, l'ont è TIM ZTE 6005.
Ora ho provato con l'sfp in eth, giusto per provare non credo porterebbe benefici, e sono passato a 20/20 mbit 🙁
aiuto!
La configurazione è questa
# 1970-01-02 03:13:30 by RouterOS 7.12.1
# software id = LCDF-MR0X
#
# model = RB4011iGS+5HacQ2HnD
# serial number =
/interface bridge
add name=LAN
add name=WAN
/interface wireless
set [ find default-name=wlan1 ] country=italy disabled=no mode=ap-bridge \
ssid=MikroTik wps-mode=disabled
set [ find default-name=wlan2 ] country=italy disabled=no mode=ap-bridge \
ssid=MikroTik wps-mode=disabled
/interface vlan
add interface=WAN name=WAN_835 vlan-id=835
/interface pppoe-client
add add-default-route=yes disabled=no interface=WAN_835 name=pppoe-out1 user=\
username
/interface wireless security-profiles
set [ find default=yes ] authentication-types=wpa-psk,wpa2-psk group-ciphers=\
tkip,aes-ccm mode=dynamic-keys supplicant-identity=MikroTik \
unicast-ciphers=tkip,aes-ccm
/ip pool
add name=DHCP_LAN ranges=192.168.88.10-192.168.88.250
/ip dhcp-server
add address-pool=DHCP_LAN interface=LAN name=DHCP_LAN
/port
set 0 name=serial0
set 1 name=serial1
/interface bridge port
add bridge=WAN interface=sfp-sfpplus1
add bridge=WAN interface=ether1
add bridge=LAN interface=ether2
add bridge=LAN interface=ether3
add bridge=LAN interface=wlan1
add bridge=LAN interface=wlan2
/ip address
add address=192.168.88.1/24 interface=LAN network=192.168.88.0
/ip dhcp-server network
add address=192.168.88.0/24 dns-server=8.8.8.8,8.8.4.4 gateway=192.168.88.1
/ip firewall filter
add action=drop chain=input dst-port=23 in-interface=WAN protocol=tcp
/ip firewall nat
add action=masquerade chain=srcnat src-address=192.168.88.0/24
/ip service
set telnet disabled=yes
set ssh disabled=yes
/system leds
add interface=wlan2 leds="wlan2_signal1-led,wlan2_signal2-led,wlan2_signal3-le\
d,wlan2_signal4-led,wlan2_signal5-led" type=wireless-signal-strength
add interface=wlan2 leds=wlan2_tx-led type=interface-transmit
add interface=wlan2 leds=wlan2_rx-led type=interface-receive
/system note
set show-at-login=no
Kreker ho fatto altri test aull eth ora va a 80/80.
Sembra cappato, dove sbaglio?
